New Products
mcmillanrodandcustom.com
Please call us @ 715-387-6847 to place an order.
HomeAbout UsRequest A CatalogLow Profile MoldingsMoldingsCustom WorkTube BumpersContact UsAir Cleaners/ScoopsPersonal ProjectsNerf BarsEventsNew ProductsInterior Moldings
36-40 FORD SINGLE CHIN BAR without NERF BARS
This was a new product that was showcased at Louisville, Kentucky for the NSRA Nationals in 2012.
Cost is $325 plus shipping and handling.


The nerfless chin bar is shown on a 1936 Ford streetrod owned by Steve Doneghy.
NEW in 2012: 32 Ford Running Board Kit
The kit includes 6 pieces (2 pcs @ 36 inches and 4 pcs. @ 32 inches.) Studs are installed.
Price for 1/2 inch moldings $395.
Price for 5/8 inch moldings $435.


BUMPERETTES
This new product was showcased at the NSRA event in Louisville, Kentucky in 2012.
The price is $215 for straight brackets and $230 with 20 degree brackets.


The bumperettes are shown on Ricky Wells' 1927 Tall T from Oklahoma.
1933-1934 FORD REAR BUMPER
Built from high quality, solid type 304 stainless steel and polished to a mirror like finish. This was displayed in the NEW PRODUCTS area at the NSRA (National Street Rod Association) event in Louisville, Kentucky August 2013. Cost is $425 plus S/H.

LOW PROFILE MOLDINGS
New in September 2014
Low profile moldings offer a lower height profile than the standard half round moldings.
They are solid, type 304 stainless steel and polished to a mirror finish.
Options for end configurations include the same as the half round. Recommended studs are an 8-32 x ¾" and are $5 each.
The cost is by the linear foot:
3/4" (3/16" thick) = $25/foot
1" (1/4" thick) = $30/foot
1 1/4" (1/4" thick) = $35/foot
BALL MILLED MOLDINGS
These moldings are 1/2" wide, solid half round and ball milled in your choice of 1/8", 3/16", and 1/4" widths. CALL 715-387-6847 FOR A PRICE QUOTE.
Machined from solid type 304 Stainless Steel and can be used for interior/exterior moldings and accents.
Options for end configurations include the same as the half round. Recommended studs are an 8-32 x ¾" and are $5 each.
Showcased at 2014 NSRA Louisville Nationals.
CHEVY NERF BARS
NEW October 2014
These Chevy Nerf bars are built specifically for early Chevrolets. They are available in 8" or 10" double bend versions with the correct 9/16" threads, allowing them to be threaded into the frame rails with a 2" shank. Built from solid type 304 stainless steel and polished to a mirror finish. They come as a set of two complete with jam nuts. (8" are $185 and 10" are $195 plus S&H.)


These nerf bars also look good on Tom Hentschell's '36 Ford.
1/2" LOW PROFILE MOLDINGS
January 2016
1/2" Low Profile Moldings are 5/32" thick and sold @ $20/foot.